Replace and Program Control Module

WARNING: This page is about a different car, the 2014 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

The steering column position control module does not require SPS programming but does require the following setup procedures after a new control module is installed:

Ignition ON.
Perform the Steering Column Tilt Wheel and Telescope Control Module Learn. Refer to Steering Column Tilt Wheel and Telescope Control Module Learn

NOTE:

If equipped with RPO A45, Seat Memory Control Module, perform the next step.

With a scan tool, Clear All DTCs.