LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2014 >> ATS Base, 2.5L Eng VIN A >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Programming And Setup - All Systems) >> Repair Instructions >> K20 Engine Control Module: Programming and Setup >> Reprogram Control Module

Reprogram Control Module

WARNING: This page is about a different car, the 2014 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

To reprogram an existing K20 Engine Control Module, perform the following procedure:

  1. Install EL-49642  SPS programming support tool.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. Clear DTCs after completing the Programming procedure.
  4. Perform the SPS Function Immobilizer Learn and follow the on-screen instructions. Refer to Immobilizer System Component Programming .
  5. Perform the SPS function Engine Control Module - Configuration & Setup and follow the on-screen instructions, if available.
  6. Clear DTCs after completing the Configuration & Setup procedure.
scientia non olet · About LEMON Manuals