LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2011 >> STS AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Diagnostic Information and Procedures >> DTC B1516 >> Circuit/System Testing

Circuit/System Testing

B1516 08

  1. Ignition OFF, disconnect the harness connector at the battery current sensor.
  2. Ignition OFF, test for less than 5.0 Ω between the low reference circuit terminal B and ground.
    • If greater than specified range , test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the BCM.
  3. Ignition ON, test for 4.8-5.2 V between the sensor supply voltage circuit terminal A and ground.
    • If less than the specified range , test the sensor supply voltage circuit terminal A for a short to ground or an open/high resistance. If the circuit test normal, replace the BCM.
    • If greater than the specified range, test the sensor supply voltage circuit for a short to voltage. If the circuit tests, normal replace the BCM.
  4. Ignition ON, test for 4.8-5.2 V between the sensor signal circuit terminal C and ground.
    • If less than the specified range, test the sensor signal circuit for a short to ground or an open/high resistance. If the circuit test normal, replace the BCM.
    • If greater than the specified range, test the sensor signal circuit for a short to voltage. If the circuit tests normal, replace the BCM.
  5. If all circuits test normal, test or replace the battery current sensor.

B1516 66 

Verify that the battery current sensor is installed securely and correctly positioned.

scientia non olet · About LEMON Manuals