LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, RWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L - Repair Instructions >> Repair Instructions >> Knock Sensor Replacement - Bank 1 >> Installation Procedure

Installation Procedure

    Fig 1: Knock Sensor & Bolt
    GM860801Courtesy of GENERAL MOTORS CORP.
  1. Install the KS.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the KS bolt and tighten to 23 N.m (17 lb ft).
    3. Fig 2: Knock Sensor Electrical Connector
    GM945742Courtesy of GENERAL MOTORS CORP.
  3. Install the KS electrical connector.
  4. Install the wiring harness heat shield to the original position.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals