1112 Cylinder Head
1112 TIGHTENING TORQUE OVERVIEW
| Flange on assembly jig | ||
| M14X30 | tightening torque | 135 Nm |
| Ball hub on the cylinder head cover/intake plenum | ||
| tightening torque | 5 Nm | |
| Cylinder head on device | ||
| M10X90x1.5 | Tightening torque | 30 Nm |
| Sliding rail to cylinder head | ||
| M6x16 | Tightening torque | 8 Nm |
| Bearing journal to cylinder head | ||
| Bearing journal Replace the bearing journal! |
Tightening torque | 22 Nm |
| Cylinder head bolt to timing case cover | ||
| M8x40 Replace screws. |
Tightening torque | 19 Nm |
| Special tool 00 2 320 to special tool 00 2 300 | ||
| M14X95 | Tightening torque | 130 Nm |
| Cylinder head to special tool 2 361 215 | ||
| Tightening torque | 35 Nm | |
| Venting connector/special tool to cylinder head | ||
| M10 | Tightening torque | 8 Nm |
| Flange on assembly jig | ||
| M14X30 | tightening torque | 135 Nm |
| Cylinder head cover to cylinder head | ||
| M6 Replace screws. |
Joining torque | 4 Nm |
| Angle of rotation | 90° | |
| Oil filler neck on cylinder head cover | ||
| M6 | tightening torque | 8 Nm |
| Oil return line in the cylinder head | ||
| M6X15 | tightening torque | 6 Nm |
| Cylinder head to crankcase | ||
| M11X188 13.9 Observe tightening sequence! Fit new cylinder head bolts. |
1. Joining torque | 50 Nm |
| 2. Angle of rotation | 180° | |
| 3. Angle of rotation | 180° | |
| Holder for the heat shield on crankcase | ||
| M6X16 | tightening torque | 8 Nm |
| Holder for the tank vent valve on crankcase | ||
| M6X16 | tightening torque | 8 Nm |
| Flange to assembly jig | ||
| M14X30 | Tightening torque | 135 Nm |