Indicator Input Test

SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section before performing repairs or service. See AIR BAG RESTRAINT SYSTEM .

1. Remove the gauge assembly from the dashboard, see Driver's Dashboard Lower Cover , then disconnect the A (30P) and C (14P) connectors from the gauge assembly.
2. Inspect the connectors and connector terminals to be sure they are making good contact.
3. If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
4. Perform the following input test at the gauge assembly A (30P) and C (14P) connectors.
   Fig 1: Gauge Assembly Connectors

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
   Fig 2: Indicator Input Test Chart (1 Of 2)

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
   Fig 3: Indicator Input Test Chart (2 Of 2)

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Connect the A (30P) and C (14P) connectors to the gauge assembly, then perform the following input test.
   Fig 4: Connecting Connectors & Performing Indicator Input Test Chart

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. If all the input tests prove OK, but the indicator is faulty, replace the printed circuit board.